SAFETY DATA SHEET
Formaldehyde 37%, ACS Grade
1. IDENTIFICATION
Product Identifiers
Product Name:
Formaldehyde 37%, ACS Grade
Other Names:
Formaldehyde, 37% microfiltered
Product Number(s):
15680, 15681, 15682, 15686, 15686-500, EMS15680, EMS15681, EMS15682, EMS15686
CAS Number:
Not available.
Recommended use of the chemical and restriction on use
Laboratory chemicals
Company Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia

(07) 4773 9444
www.proscitech.com
Emergency Contact Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia

(07) 4773 9444
www.proscitech.com
2. HAZARDS IDENTIFICATION
Classification of the substance or mixture
GHS02 Flame
Flam. Liq. H226 Flammable liquid and vapour
GHS06 Skull and crossbones
Acute Tox. 3 H311 Toxic in contact with skin
Acute Tox. 3 H331 Toxic if inhaled
GHS08 Health hazard
Muta. 2 H341 Suspected of causing genetic defects.
Carc. 1B H350 May cause cancer.
STOT SE 1 H370 Causes damage to organs.
GHS05 Corrosion
Skin Corr. 1B H314 Causes severe skin burns and eye damage.
Eye Dam. 1 H318 Causes serious eye damage.
GHS07
Acute Tox. 4 H302 Harmful if swallowed
Skin Sens. 1 H317 May cause an allergic skin reaction.
Label Elements
Signal Words
Danger
Hazard Statement(s)
Flammable liquid and vapour.
Harmful if swallowed.
Toxic in contact with skin.
Toxic if inhaled.
Causes severe skin burns and eye damage.
May cause an allergic skin reaction.
Suspected of causing genetic defects.
May cause cancer.
Causes damage to organs.
Precautionary Statement(s)
Obtain special instructions before use.
Do not handle until all safety precautions have been read and understood.
Keep away from heat/sparks/open flames/hot surfaces. No smoking.
Ground/bond container and receiving equipment.
Use explosion-proof electrical/ventilating/lighting equipment.
Use only non-sparking tools.
Take precautionary measures against static discharge.
Do not breathe dusts or mists.
Wash thoroughly after handling.
Do not eat, drink or smoke when using this product.
Use only outdoors or in a well-ventilated area.
Contaminated work clothing should not be allowed out of the workplace.
Wear protective gloves/protective clothing/eye protection/face protection.
Primary route(s) of entry
Not available
Human Health
Inhalation:
Remove victim to fresh air and keep at rest in a position comfortable for breathing.
Ingestion:
Rinse mouth. Do NOT induce vomiting. Call a POISON CNETRE/doctor if you feel unwell.
Eyes:
Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
Skin:
(or hair) Remove/take off immediately all contaminated clothing. Rinse skin with water/shower. If skin irritation or rash occurs get medical advice/attention.
Environment
Store in a well-ventilated place. Keep container tightly closed. Keep cool. Store locked up. Dispose of contents/container in accordance with local/regional/national/international regulations.
3. COMPOSITION/INFORMATION ON INGREDIENTS
Name
CAS No.
Content (w/w)
Classification
Formaldehyde
50-00-0
>25-≤50%
Mixture
Methyl Alcohol
67-56-1
>10-≤25%
Mixture
4. FIRST AID MEASURES
Ingestion
Call for a doctor immediately. Drink plenty of water and provide fresh air. Call for a doctor immediately.
Inhalation
Supply fresh air or oxygen; call for doctor. In case of unconsciousness place patient stably in side position for transportation.
Skin Contact
Immediately was with water and soap and rinse thoroughly.
Eye Contact
Rinse opened eye for several minutes under running water. Then consult a doctor.
Other Information
Immediately remove any clothing soiled by the product. Symptoms of poisoning may even occur after several hours; therefore medical observation for at least 48 hours after the accident. Remove breathing equipment only after contaminated clothing have been completely removed. In case of irregular breathing or respiratory arrest provide artificial respiration.
5. FIREFIGHTING MEASURES
Suitable extinguishing equipment
CO₂, powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
HAZCHEM
No further relevant information available.
Special protective equipment and precautions for fire fighters
Mouth respiratory protective device.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
Wear protective equipment. Keep unprotected persons away.
Environmental precautions
Dilute with plenty of water. Do not allow to enter sewers/surface or ground water.
Methods and materials for containment and clean up
Absorb with liquid-binding material (sand, diatomite, acid binders, sawdust). Use neutralising agent. Dispose contaminated material as waste according to item 13. Ensure adequate ventilation.
7. HANDLING AND STORAGE
Precautions for safe handling
Ensure good ventilation/exhaustion at the workplace.
Open and handle receptacle with care.
Prevent formation of aerosols.
Protect from heat.
Protect against electrostatic charges.
Keep respiratory protective device available.
Conditions for safe storage
Keep container tightly sealed.
Protect from heat and direct sunlight.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Standards
Material
TWA ppm
TWA mg/m3
STEL ppm
STEL mg/m3
Formaldehyde
1ppm
1.2mg/m³
2ppm
2.5mg/m³
Methyl Alcohol
200ppm
262mg/m³
250ppm
328mg/m³
Engineering controls
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Store protective clothing separately.
Avoid contact with the eyes.
Avoid contact with the eyes and skin.
Personal protective equipment
Eye and face protection
Tightly sealed goggles.
Skin protection
Not available.
Body protection
Wear protective gloves. The glove material has to be impermeable and resistant to the product/the substance/the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
Respiratory protection
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device.
9. PHYSICAL AND CHEMICAL PROPERTIES
General information
Appearance
Undetermined coloured liquid
Odour
Strong
pH
7 at 20°C
Vapour Pressure
128hPa at 20°C
Density
0.9045g/cm³ at 20°C
Boiling Point
64°C
Melting Point
Undetermined
Solubility
Fully miscible
Specific Gravity of Density
Not available
Flash Point
60°C
Flammable (Explosive) Limits
Lower: 5.5Vol %
Upper: 73Vol %
Ignition Temperature
Product is not selfigniting.
Formula
Not available
10. STABILITY AND REACTIVITY
Reactivity
No further relevant information available.
Chemical stability
No decomposition if used according to specifications.
Possibility of hazardous reactions
No dangerous reactions known.
Conditions to avoid
No further relevant information available.
Incompatible materials
No further relevant information available.
11. TOXICOLOGICAL INFORMATION
Acute effects
Not available
Eye contact
Strong caustic effect. Strong irritant with the danger of severe eye injury.
Skin contact
Strong caustic effect on skin and mucous membranes.
Ingestion
Swallowing will lead to a strong caustic effect on mouth and throat and to the danger of perforation of esophagus and stomach.
Inhalation
Sensitisation possible through skin contact.
Toxicity and irritation
Toxic
Harmful
Corrosive
Irritant
Carcinogenic
12. ECOLOGICAL INFORMATION
Ecotoxicity
No further relevant information available.
Persistence and degradability
No further relevant information available.
Bioaccumulative potential
No further relevant information available.
Other adverse effects
Water hazard class 2: Hazardous for water.
Do not allow product to reach ground water, water course or sewage system.
Must not reach sewage water or drainage ditch undiluted or unneutralised.
Danger to drinking water if even small quantities leak into the ground.
13. DISPOSAL CONSIDERATIONS
General information
Must not be disposed together with household garbage. Do not allow product to reach sewage system. Disposal must be made according to official regulations. Recommended cleansing agents: Water, if necessary together with cleansing agents.
14. TRANSPORT INFORMATION
ADG label required
HAZCHEM
No further relevant information available.

UN Number
UN1198
Proper shipping name
1198 FORMALDEHYDE SOLUTION, FLAMMABLE
Transport hazard class
Class 3 Flammable liquids
Label 3+8
Packing group
III
Environmental hazard
Not applicable.
Special precautions for users
Warning: Flammable liquids.
Hazard identification number (Kemler code): 38
EMS Number: F-E,S-C
Stowage code SW2 Clear of living quarters.
Additional information
ADG
Limited quantities (LQ) 5L
Excepted quantities (EQ) Code: E1
Maximum net quantity per inner packaging: 30mL
Maximum net quantity per outer packing: 1000mL
Transport category 3
Tunnel restriction code D/E
IMDG
Limited quantities (LQ) 5L
Excepted quantities (EQ) Code:E0
Not permitted as Excepted Quantity
15. REGULATORY INFORMATION
Poisons Schedule Number
50-00-0 Formaldehyde S2, S6, S10
67-56-1 Methyl Alcohol S5, S6
Other Information
16. OTHER INFORMATION
SDS preparation date
28 November 2024
Comments
This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.
This Safety Data Sheet (SDS) has been prepared in compliance with the Preparation of Safety Data Sheets for Hazardous Chemicals Code of Practice February 2016. It is the user's responsibility to determine the suitability of this information for adoption of necessary safety precautions. The information published in this SDS has been compiled from the publications listed in Section 16: to the best of our ability and knowledge these publications are considered accurate. We reserve the right to revise Safety Data Sheets as new information becomes available. Copies may be made for non-profit use.

... End of SDS ...