SAFETY DATA SHEET
FIRM for Acrylic Resin Sections
1. IDENTIFICATION
Product Identifiers
Product Name:
Cresyl fast violet fluorescent dye (FIRM) for Acrylic Resin Sections
Other Names:
Cresyl fast violet fluorescent dye
Product Number(s):
EMS12780-05; 12780-05
CAS Number:
-
Recommended use of the chemical and restriction on use
Laboratory use
Company Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia

(07) 4773 9444
www.proscitech.com
Emergency Contact Details
ProSciTech Pty Ltd
11 Carlton Street
KIRWAN QLD 4817
Australia

(07) 4773 9444
www.proscitech.com
2. HAZARDS IDENTIFICATION
Classification of the substance or mixture
GHS02 Flame
Flammable Liquids 2 H225 Highly flammable liquid and vapour
GHS08 Health hazard
Carcinogenicity 1A H350 May cause cancer.
Label Elements
Signal Words
Danger
Hazard Statement(s)
H225 Highly flammable liquid and vapour
H351 Suspected of causing cancer
Precautionary Statement(s)
P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have been read and understood.
P210 Keep away from heat, hot surface, sparks, open flames and other ignition sources. - No smoking.
P233 Keep container tightly closed.
P240 Ground/bond container and receiving equipment.
P241 Use explosion-proof [electrical/ventilating/lighting/.../] equipment.
P242 Use only non-sparking tools.
P243 Take precautionary measures against static discharge.
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P303+P361+P353 IF ON SKIN (or hair): Take off Immediately all contaminated clothing. Rinse SKIN with water [or shower].
P308+P311 IF exposed or concerned: Call a POISON CENTER/doctor/...
P370+P378 In case of fire: Use CO₂, sand, extinguishing powder. Do not use water to extinguish.
P403 Store in a well-ventilated place.
P404 Store in a closed container.
P405 Store locked up.
P501 Dispose of contents/container in accordance with local/regional/national/international regulations.
Primary route(s) of entry
Inhalation, ingestion
Human Health
Inhalation:
Ingestion:
Eyes:
Skin:
Environment
3. COMPOSITION/INFORMATION ON INGREDIENTS
Name
CAS No.
Content (w/w)
Classification
Ethyl alcohol
64-17-5
>50-≤100%
Mixture of the substances listed below with nonhazardous additions.
4. FIRST AID MEASURES
Ingestion
If symptoms persist consult doctor.
Inhalation
Supply fresh air; consult doctor in case of complaints
Skin Contact
Generally the product does not irritate the skin.
Eye Contact
Rinse opened eye for several minutes under running water.
Other Information
No further relevant information available.
5. FIREFIGHTING MEASURES
Suitable extinguishing equipment
CO₂, sand, extinguishing powder. DO NOT USE WATER.
HAZCHEM
No further relevant information available.
Special protective equipment and precautions for fire fighters
No further relevant information available.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
Wear protective equipment. Keep unprotected persons away.
Environmental precautions
Do not allow to enter sewers/ surface or ground water.
Methods and materials for containment and clean up
Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).
Ensure adequate ventilation.
Do not flush with water or aqueous cleansing agents
7. HANDLING AND STORAGE
Precautions for safe handling
No special precautions are necessary if used correctly.
Conditions for safe storage
Store in a cool location.
Keep receptacle tightly sealed.
Keep ignition sources away - Do not smoke.
Protect against electrostatic charges.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Standards
Material
TWA ppm
TWA mg/m3
STEL ppm
STEL mg/m3
64-17-5 Ethyl alcohol
1000 ppm
1900 mg/m³
1000ppm
-
Engineering controls
Wash hands before breaks and at the end of work
Personal protective equipment
Eye and face protection
Tightly sealed goggles
Skin protection
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
Body protection
Not required
Respiratory protection
Not required
9. PHYSICAL AND CHEMICAL PROPERTIES
General information
Appearance
Liquid
Odour
Characteristic
pH
Not determined
Vapour Pressure
at 20 °C (68 °F): 59 hPa (44.3 mm Hg)
Density
Not determined
Boiling Point
78 °C (172.4 °F)
Melting Point
Undetermined
Solubility
Not miscible or difficult to mix
Specific Gravity of Density
Not determined
Flash Point
13 °C (55.4 °F)
Flammable (Explosive) Limits
Highly flammable - Product is not explosive. However, formation of explosive air/vapour mixtures are possible. Explosion limits:
Lower: 3.5 Vol %
Upper: 15 Vol %
Ignition Temperature
425 °C (797 °F) - Product is not selfigniting
Formula
Solvent content:
Organic solvents: 70.0 %
VOC content: 70.00 %
700.0 g/l / 5.84 lb/gal
10. STABILITY AND REACTIVITY
Reactivity
No further relevant information available
Chemical stability
No decomposition if used according to specifications.
Possibility of hazardous reactions
No dangerous reactions known
Conditions to avoid
No further relevant information available
Incompatible materials
No further relevant information available
11. TOXICOLOGICAL INFORMATION
Acute effects
No further relevant information available
Eye contact
No further relevant information available
Skin contact
No further relevant information available
Ingestion
No further relevant information available
Inhalation
No further relevant information available
Toxicity and irritation
No further relevant information available
12. ECOLOGICAL INFORMATION
Ecotoxicity
No further relevant information available
Persistence and degradability
No further relevant information available
Bioaccumulative potential
No further relevant information available
Other adverse effects
No further relevant information available
13. DISPOSAL CONSIDERATIONS
General information
Must not be disposed of together with household garbage.
Water hazard class 1 (Self-assessment): slightly hazardous for water
Do not allow undiluted product or large quantities of it to reach ground water, water course or sewage system.
14. TRANSPORT INFORMATION
ADG label required
HAZCHEM
No further relevant information available.

UN Number
UN1170
Proper shipping name
ETHANOL mixture
Transport hazard class
Class 3
Packing group
PG II
Environmental hazard
Not applicable
Special precautions for users
Warning: Flammable liquids
Additional information
Hazard identification number (Kemler code): 33
· EMS Number: F-E,S-D
· Stowage Category A
Limited quantities (LQ) 1L
Excepted quantities (EQ) Code: E2
Maximum net quantity per inner packaging: 30 mL
Maximum net quantity per outer packaging: 500 mL
UN 1170 ETHANOL (ETHYL ALCOHOL) MIXTURE, 3, II
15. REGULATORY INFORMATION
Poisons Schedule Number
No further relevant information available.
Other Information
No further relevant information available.
16. OTHER INFORMATION
SDS preparation date
1 November 2024
Comments
This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship.
This Safety Data Sheet (SDS) has been prepared in compliance with the Preparation of Safety Data Sheets for Hazardous Chemicals Code of Practice February 2016. It is the user's responsibility to determine the suitability of this information for adoption of necessary safety precautions. The information published in this SDS has been compiled from the publications listed in Section 16: to the best of our ability and knowledge these publications are considered accurate. We reserve the right to revise Safety Data Sheets as new information becomes available. Copies may be made for non-profit use.

... End of SDS ...